Tapered mast as original (.100 at ball; .185 at mast).
Has correct .305 size ball.
This stainless steel antenna mast measures 31 1/2 inches overall length, with a thread size of 1/4 inch x 20.
…
This die cast, chrome plated spacer is angled.
The short side is 1/4 inch tall.
The tall side is 7/16.
O.D. = 1 5/16
I.D. = 3/4
There is a flange at the bottom which fits/snaps into gasket 162039
There is also a locator pin…
Black plastic push-in guide, 1978 through 1979 1st design mounting hole in the rear body deck is sloped downwards towards rear. For use with factory style power antenna only.
…
Correct reproduction zinc diecast chrome plated antenna nut used on all 65-68 Corvettes.
This antenna nut cap has the correct flats on the side of the nut and stepped lower edge where the nut mounts on top of the antenna bezel.
Hole…
Reproduction Of Original
The mast section of the antenna consists of four round chrome sections, three telescoping sections, and one fixed section, with an approximately 1/4" ball-shaped tip at the end of the mast. The overall…
High quality stainless steel OER® reproduction of the original telescoping antenna mast for various GM models. Features include a round body and tip, and threaded end (with jam nut) that screws into the antenna base. Measures from…
Chrome flat style (non-domed) bezel nut which inserts under the antenna bezel nut on top of the fender. Applications: 1969 Camaro 1969 Firebird 1969-78 Corvette 1969 Impala/Full Size (non-power ant ennas) 1973-96 Impala/Full Size (power…
OER® reproduction of the original GM AM/FM non-telescopic stainless steel fixed antenna mast for use on various GM models with an AM/FM radios including 1969 Camaros and Firebirds. Measures 30" non-retractable style round mast. Replaces…
OER® chrome antenna bezel nut which goes on top of the antenna bezel. Hole in nut is 9/16" id. Applications 1967-68 Camaro 1970-81 Camaro 1967-68 Firebird 1970-81 Firebird 1965-68 Corvettei> 1968-69 Chevy II / Nova (Front) 1965-67…
Reproduction Of Original
The most common electrical problem in a Corvette is a bad ground. The Corvette with its electrically non-conductive fiberglass body requires the use of ground straps for everything from preventing…
Correct OER® reproduction of the original antenna body for use with 1967-72 AM or AM/FM antennas. Includes the complete body assembly as shown. Features the non-threaded end for the push-on style cable connector. Important: For use with…