Molded "S"-shaped fuel pump inlet hose kit, goes from long line to pump. It measures 5/8 inch outer diameter x 3/8 inch inner diameter. Has a 6-inch reach in its natural, unstraightened, "S"-shape.
C3 CORVETTE RUBBER FLEX FUEL GAS LINES…
This universal fuel tank anti squeak kit is used to cushion the gas tank from the body and straps to reduce irritating metal to metal noise. Cushions are 38" long and include anti-pop pad for top of fuel tank. Cut to length.
This…
Prevent fuel tank squeaks and rattles with these low density, nonasbestos, cellulose fiber material with high rubber filler content, tank mounting pads.
…
Owners of classic Chevrolet Corvettes recognize the incredible importance of a reliable fuel supply. A vented gas cap provides the chance for a necessary amount of breathing for the fuel tank both relieving it against pressure build-ups in…
This 1984-1996 Corvette Fuel Filler Boot is a great looking reproduction of the GM original. This black rubber boot/housing easily slips over the fuel filler neck and seals the fuel tank to the vehicle body. The boot is molded of flexible…
Replacement Brass Fitting
1/4 npt Male Thread x 3/8 Tube Female Thread inv Flare
Fits 1963 All
Fits 1964-66 All Except Special High Performance
Fits 1965- 396ci
Fits 1966 All With 427ci & Correct Fuel Pump
Fits…
Set of 8
22LB HR @ 43.5 PSI
Flow matched to ensure uniformity of spray
Viton O-Rings
Fully Remanufactured by State of the Art Fuel Inector Service Equipment
3 Year Guarantee
…
Everything You Need To Install
1970 With E.E.C. (Evaporation Emission Control) Without LT1
Fits 1971-72 Without LT1
Fits 1973-74 All Models
Includes Gas Tank, Sending Unit, Gas Tank Straps, Filler Neck Boot and Filler Neck…
Prevents Fuel From Splashing
Lifetime Guarantee
You'll never have to worry about losing your gas cap again!! The Perma Cap Self-Sealing Gas Cap is a snap to install, and it's polycarbon fiberglass resists solvents…
Now you can replace your sending unit with this replacement without paying the high cost for a fuel pump. Also, if you just replaced your fuel pump, just install it in this new sending unit. All hardware to install is…
OER® reproduction of the original grommet and sleeve unit where the accelerator rod fits into linkage. This grommet often deteriorates due to engine heat or chemical spillage. Replacing the grommet will keep your throttle rod from…
Includes Filler Neck Screw Set, Filler Neck Cork Gasket, Sending Unit Lock Ring and Sending Unit Retaining Cam.
Replacement Gas Tank
Identical To Reproduction Except Without O.L. Anderson Logo
1970 With E.E.C. (Evaporation…