Proper end play is critical to your Corvette's rear wheel bearing's life; a few thousandths of an inch over or under can result in premature bearing failure and more expensive repairs. This tool takes the place of the actual spindle flange during setup.
Using this setup tool, you can check the end play of new rear bearing assemblies before pressing them onto the spindle. This makes proper shim selection simple and does not require repeated pressing on and off the bearings.
Bearings and shims are sold separately.
Large journal dimension = 1.3745 inch
BUYER BEWARE!
Watch for imitations. These are American-made, anything you find cheaper may be a foreign-made copy of this tool.
SPINDALS SPINDLES TOOLS
Vehicle Fitment:
The Vehicle Fitment Guide is to be used as a general reference. The data has been provided by our suppliers and manufacturers and may contain errors or incorrect data. Always refer to a professional to verify correct fitment for your vehicle.
| Make |
Model |
Years |
| Chevrolet |
Corvette |
1963 - 1982 |
