The role of the Clutch Linkage Retainer Clip is to hold the cable in place and prevent it from moving around ensuring functionality and longevity. You will find the fit and function meets all GM specifications. This clutch linkage retainer…
Split nylon flange bushings fit over clutch pedal cross shaft and inside cross shaft sleeve for clutch and brake pedals with 5/8" diameter cross shaft. These OER® reproduction bushings will help eliminate excessive side to side…
Best Quality Reproduction Brake & Clutch Pedal Bushings
Plastic Sleeve Bushings As Original
Set Of 4
For Brake Pedal On Full Size With Automatic Transmission
For Clutch & Brake Pedal On Full Size With Manual…
The clutch cross shaft is a piece of steel that slides into the transmission case, and it is the pivot point for the fork that pushes onto you clutch diaphragm. Basically, if it were to fall out you wouldn't be able to operate the clutch…
This 1963-1981 Corvette Clutch Pivot Stud Nylon Seat is made to original specifications and is the perfect fit for your 1963-1981 Corvette. It is designed to meet, or exceed, original performance.
Replacement Stud
2…
Set of four reproduction pedal shaft bushings. Used with all automatic and manual pedals. Group 0.831 and 4.626 GM Part #: 3798256, 3965692, 1247439, 140048221…
The clutch cross shaft is a piece of steel that slides into the transmission case, and it is the pivot point for the fork that pushes onto you clutch diaphragm. Basically, if it were to fall out you wouldn't be able to operate the clutch…
Set of 2 3/8-16 Hex Jam Nuts used to mount the 63-81 Clutch Pedal Push Rod Swivel , 69-76 Headlight Door Open Warning Swiches and 74-77 Theft Alarm Switch
RODS NUTS PEDALS NUTS
…
Gray Felt/Seal with 8oz flex embossed vinyl (.012" Thick) skin applied to both sides.
You will need to make seveal small slits on the ID so they will slide over the clutch ball stud.C1 CORVETTE TRANSMISSION CLUTCH SEALS…
Best Quality Reproduction Brake Or Clutch Pedal Pin Clip
Correct Spring Steel
Fits All 5/8" Diameter Pins
For Automatic Transmission Brake Pedals & Manual Transmission Clutch/Brake Pedals
The brake and clutch pedal…
Accurately machined Frame pivot ball stud fits all original and reproduction big and small block clutch bellcranks. Unlike cheap knock-offs offered elsewhere, ours are heat treated for hardness as original. Black oil finish. Overall length…
Replacement Stud
This Corvette replacement clutch cross shaft frame stud has been manufactured to meet or exceed factory specifications and performance. You will find the fit and function will work perfectly for your…